高居里温度铁电单晶PIN-PT的机电性能

弛豫铁电单晶Pb(In_1/2Nb_1/2)O₃-PbTiO₃(PIN-PT)相较于常用的Pb(Mg_1/3Nb_2/3)O₃-PbTiO₃(PMN-PT)具有更高的居里温度,在高稳定性、高性能的传感器、换能器方面具有应用前景。本工作采用谐振法研究了[001]方向极化的0.66PIN-0.34PT铁电单晶的全矩阵机电性能参数。0.66PIN-0.34PT 单晶的三方-四方相变温度(T_RT)约为160 ℃,居里温度(T_C)约为260 ℃,室温压电系数d₃₃、d₃₁、d₁₅分别为1 340 pC/N、-780 pC/N、321 pC/N,介电常数ε^T₃₃、ε^S₃₃、ε^T₁₁、ε^S₁₁分别为2 700、905、2 210、1 927,机电耦合系数 k₃₃、k₃₁、k₁₅、k_t分别为 87%、58%、38%、61%。其纵向压电常数(d₃₃)和纵向机电耦合系数(k₃₃)小于 PMN-PT 单晶,但是横向压电性能(d₃₁)和剪切压电性能(d₁₅)都略高于PMN-PT单晶。另外,研究了机电耦合性能随温度的变化趋势,发现0.66PIN-0.34PT单晶在150 ℃以下有较好的温度稳定性。     

Rapid and easy quantification of elemental sulphur in aqueous samples from biological reactors: the turbidimetric method revisited

Recent developments in wastewater treatment have led to a renewed interest to obtain elemental sulphur (S°) as a by-product from bioreactors. However, practical studies are limited by the gap of adequate analytical techniques for its determination. This paper provides a statistical study and matrix effect evaluation of an adapted spectrophotometric method for routine S° analyses in aqueous samples, based on a methodology previously described by Hart (1961). Four complex matrices were tested: domestic sewage and effluent samples from three different bioreactors. Tested performance criteria included linearity, matrix effect, limit of detection and quantification and S° recovery. Results were linear (R² = 0.99994) in the studied range (5 to 100 mg S° L^?1) and no matrix effect was observed. The accuracy was based on recovery values that varied from 100% to 106%. The colloidal S° separation and extraction protocol was also considered suitable for aqueous samples, reaching more than 99.0% of S° recovery.     

SIMS of organic layers with unknown matrix parameters: Locating the interface in dual beam argon gas cluster depth profiles

Four simple methods are evaluated to determine their accuracies for establishing the interface location in secondary ion mass spectrometry intensity depth profiles of organic layers where matrix effects have not been measured. Accurate location requires the separate measurement of each ion's matrix factor. This is often not possible, and so estimates using matrix-less methods are required. Six pure organic material interfaces are measured using many secondary ions to compare their locations from the four methods with those from full evaluation with matrix terms. For different secondary ions, matrix effects cause the apparent interface positions to vary over 20 nm. The shifts in the intensity profiles on going from a layer of P into a layer of Q are in the opposite direction to that for going from Q into P, so doubling layer thickness errors. The four methods are as follows: M1, use of the median interface position in the intensity profiles for the five lightest ions for 15 ≤ m/z ≤ 150; M2, extrapolation of the position for each ion to m/z = 0 for ions with m/z ≤ 150; M3, as M2 but for m/z ≤ 300; and M4, the extreme positions for all m/z ≤ 100. Comparison with the location using matrix terms shows their ranking, from best to worst, to be M4, M3, M1, and M2 with average errors of 10%, 12%, 14%, and 17%, respectively, of the profile interface full widths at half maximum. Use of pseudo-molecular ions is very much poorer, exceeding 50%, and should be avoided.     

Extremal generalized centralizers in matrix algebras

We describe matrices with extremal generalized centralizers over algebraically closed fields.     

Maximal Subrings and Covering Numbers of Finite Semisimple Rings

We classify the maximal subrings of the ring of n×n matrices over a finite field, and show that these subrings may be divided into three types. We also describe all of the maximal subrings of a finite semisimple ring, and categorize them into two classes. As an application of these results, we calculate the covering number of a finite semisimple ring.     

树状大分子接枝型聚合物色谱分离材料研究进展

随着色谱固定相制备技术和材料科学领域的不断发展,目前已经有大量修饰方法和新型材料被用于固相萃取、高效液相色谱以及离子色谱聚合物固定相填料的功能化修饰。其中聚酰胺-胺(PAMAM)树状大分子由于其独特的结构和性质,在色谱分离材料结构完善和性能提升中也发挥了重要的作用。该文主要综述了PAMAM树状大分子在以聚合物为基质的色谱分离材料修饰中的应用,并对其今后的发展进行了展望。     

Mass spectrometry imaging of latent fingerprints using titanium oxide development powder as an existing matrix

Recent research has focused on increasing the evidentiary value of latent fingerprints through chemical analysis. Although researchers have optimized the use of organic and metal matrices for matrix‐assisted laser desorption/ionization‐mass spectrometry imaging (MALDI‐MSI) of latent fingerprints, the use of development powders as matrices has not been fully investigated. Carbon forensic powder (CFP), a common nonporous development technique, was shown to be an efficient one‐step matrix; however, a high‐resolution mass spectrometer was required in the low mass range due to carbon clusters. Titanium oxide (TiO₂) is another commonly used development powder, especially for dark nonporous surfaces. Here, forensic TiO₂ powder is utilized as a single‐step development and matrix technique for chemical imaging of latent fingerprints without the requirement of a high‐resolution mass spectrometer. All studied compounds were successfully detected when TiO₂ was used as the matrix in positive mode, although, generally, the overall ion signals were lower than the previously studied CFP. TiO₂ provided quality mass spectrometry (MS) images of endogenous and exogenous latent fingerprint compounds. The subsequent addition of traditional matrices on top of the TiO₂ powder was ineffective for universal detection of latent fingerprint compounds. Forensic TiO₂ development powder works as an efficient single‐step development and matrix technique for MALDI‐MSI analysis of latent fingerprints in positive mode and does not require a high‐resolution mass spectrometer for analysis.     

振型归一化对梁结构柔度曲率损伤指标的影响

结构柔度矩阵需由质量矩阵归一化振型获得,而质量矩阵归一化振型难以直接测得,限制了柔度曲率类损伤指标的应用。为分析振型归一化方法对梁结构柔度曲率类损伤指标的影响,根据梁结构的刚度、弯矩和位移曲率的关系,建立了均布荷载作用下结构损伤前后位移曲率与损伤程度的理论表达式,实现定量分析均匀荷载面曲率结构损伤程度。提出P-范数振型归一化方法,通过均匀荷载面曲率指标推导了振型质量矩阵归一化系数差x_α与损伤程度的关系。以三跨连续梁算例对理论进行了验证,结果表明,损伤程度定量指标效果良好,不同P-范数振型归一化方法下,损伤程度的偏差可由2x_α估算;2-范数振型归一化方法的损伤识别结果与质量矩阵振型归一化结果最接近,故当无法获得质量矩阵归一化振型时,可采用2-范数归一化振型代替。     

Flavonoid glycosides from Persea caerulea. Unraveling their interactions with SDS‐micelles through matrix‐assisted DOSY,PGSE, mass spectrometry,and NOESY

Two flavonoid glycosides derived from rhamnopyranoside ( 1 ) and arabinofuranoside ( 2 ) have been isolated from leaves of Persea caerulea for the first time. The structures of 1 and 2 have been established by ¹H NMR, ¹³C NMR, and IR spectroscopy, together with LC–ESI–TOF and LC–ESI–IT MS spectrometry. From the MS and MS/MS data, the molecular weights of the intact molecules as well as those of quercetin and kaempferol together with their sugar moieties were deduced. The NMR data provided information on the identity of the compounds, as well as the α and β configurations and the position of the glycosides on quercetin and kaempferol. We have also explored the application of sodium dodecyl sulfate (SDS) normal micelles in binary aqueous solution, at a range of concentrations, to the diffusion resolution of these two glycosides, by the application of matrix‐assisted diffusion ordered spectroscopy (DOSY) and pulse field gradient spin echo (PGSE) methodologies, showing that SDS micelles offer a significant resolution which can, in part, be rationalized in terms of differing degrees of hydrophobicity, amphiphilicity, and steric effects. In addition, intra‐residue and inter‐residue proton–proton distances using nuclear Overhauser effect build‐up curves were used to elucidate the conformational preferences of these two flavonoid glycosides when interacting with the micelles. By the combination of both diffusion and nuclear Overhauser spectroscopy techniques, the average location site of kaempferol and quercetin glycosides has been postulated, with the former exhibiting a clear insertion into the interior of the SDS‐micelle, whereas the latter is placed closer to the surface. Copyright © 2016 John Wiley & Sons, Ltd.